Checkboxes next to the host and adapter entries are used to select or deselect an entry. Enabling Authentication Enabling authentication is a two step process. Not available in read-only mode or on Windows XP or Vista. In the discovery tree, click the adapter. Once you have entered the necessary information, you are notified when the installation of the HBAnyware Web Launch package is complete. 
| Uploader: | Moogujinn |
| Date Added: | 1 March 2009 |
| File Size: | 60.57 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 90540 |
| Price: | Free* [*Free Regsitration Required] |
This driver For detail on this property is ignored when property is ignored when LPFC parameter, enable-auth is set to 0.
(PDF) HBAnyware ® Utility | Дмитрий Сапожников -
A malfunction error indicates that the system has problems, but user intervention is not required. The HBAnyware utility repository can be found in the following paths: Persistent binding is not supported by the Linux 2. Use ACK0 for Description: Add Persistent Binding dialog box 5. For detailed description of the mode, please refer to the Emulex HBAnyware hbbanyware.
In the habnyware tree, select the port whose VPD information you want to view. This property represents a table of entries. Too few IOCBs can temporarily prevent the driver from communicating with the adapter, thus lowering per- formance. Resetting All Default Values To reset all parameter values to their default factory values, click Defaults. This is a bit worldwide unique identifier assigned to the fabric.
It also has the advantage that the new WWPN is unique. Install the RPM by entering the following command all on one line: The blinking pattern acts as a beacon, making it easier to locate a specific adapter among racks of other adapters.
In the discovery-tree, select the adapter port whose target mapping information you want to view.
However, there can be times where these do not match. Select the Maintenance tab, check enable adapter boot and click Configure Boot.
Also, any change you make to the adapter port names in your discovery-tree are seen only by you; users running the HBAnyware utility on another host do not see your name changes.
It is only valid when driver property enable-auth is set to 1.
This value overrides lun-queue-depth. To enable the HTTP port: In the discovery-tree, select the LUN whose information you want to view. The authentication hash list 4 digits. Enabling Authentication Enabling authentication is a two step emmulex. Select the Maintenance tab and click Update Firmware.
The default is minutes. To override a driver parameter for a single driver-loading session, specify it as a driver property to the modload command. The stan- dard HBAnyware user interface is displayed. Without knowing this, you could configure a boot type but not be able to boot from it since the adapter lacks the correct boot code.
This command takes down the netlink connection between the fcauthd daemon nd the lpfc driver, and stops the fcauthd daemon. A file selection dialog box appears.
Using Emulex HBAnyware Utility to reset HBA
The Mapped Target Settings dialog box appears. Select your host from the discovery tree. Dynamic parameters do not require the driver to be unloaded and reloaded for changes to take effect.
No comments:
Post a Comment